The points need attention to purchase JIS SB410 pressure vessel steel sheet

We are world class steel materials supplier. We are engaed in providing raw steel materials such as JIS SB410 pressure vessel steel sheet steel plates / steel coils / steel sheets / steel pipes, deep processing and a series project design and solutions to clients. We guarantee to return goods for free for quality problem during its lifetime. Your satisfactory is our permanent pursue. We always welcome advise from clients to make self-improvement continously. And sincerely to build JIS SB410 pressure vessel steel sheet long-term cooperation with you.

SA36 carbon structural steel is a material belonging to the ASME boiler and pressure vessels. The products are produced in steel plates, steel sheets, steel bars, and section steels. The tensile strength is 400-550MPa; the yield point is greater than or equal to 250MPa. SA-36 steel production process: the steel is killed steel. Detailed specifications: JIS SB410 pressure vessel steel sheet thickness: 8-100mm, width: 1600-4020mm, length: 6000-17500mm. It is commonly used in the construction of bridges and buildings.

Low-alloy steel plates have low carbon content, and because ferrosilicon is not used for deoxidation, the silicon content in steel is often <0.07%. The outer layer of rimmed steel is crystallized in a rimmed state, so the surface layer is pure and dense, the surface quality is good, and the Zhengzhou low alloy steel plate JIS SB410 pressure vessel steel sheet has good processing performance. Rimmed steel does not have large concentrated shrinkage cavities, uses less deoxidizer, and the cost of steel is low.

The preparation of JIS SB410 pressure vessel steel sheet galvanized steel before welding is the same as that of ordinary low-carbon steel. It is necessary to carefully handle the groove size and nearby galvanized layer. In order to achieve penetration, the groove size shall be appropriate, generally 60 ~ 65 °, with a certain gap, generally 1.5 ~ 2.5mm; in order to reduce the penetration of zinc into the weld, the galvanized layer in the groove can be removed before welding. In the practical work, the centralized beveling, no blunt edge technology for JIS SB410 pressure vessel steel sheet centralized control, two-layer welding process, reducing the possibility of incomplete penetration.

JIS SB410 pressure vessel steel sheet, Grade P295GH chemical composition under EN10028-2:2003 is displayed as follows. Chemical composition (C: 0.08 to 0.20; Cr: ≤0.30; Si: ≤0.40; Cu: ≤0.30;Mn: 0.90 to 1.50; Mo: ≤0.08;P: ≤0.025; Nb: ≤0.020;S: ≤0.015; Ni: ≤0.30;Al: ≤0.020; Ti: 0.03; N: ≤0.012; Vi: ≤0.02). The yield Strength MPa (min) of P295GH steel plate with thickness less than 16mm is 295MPa, and the tensile strength is 460-580MPa.

In addition to quality assurance, service is also important for the competition of steel suppliers. All the after-sales service personnel of the company have received professional training and assessment. The steel products supplied by our company enjoy the life-long quality problem replacement service. In the process of using our steel JIS SB410 pressure vessel steel sheet products, if there is any problem, just contact us in time, and our after-sales service personnel will look for countermeasures and solve the problem with you as soon as possible.