The specifications available for AH36 hull structure steel, pressure vessel plates are: thickness 8-700mm, width 1500-4200mm, length 4000-17000mm, and unit weight up to 3000 tons Our company can provide cutting, welding, drilling and turning services if required Available flaw detection requirements: Z15-Z35 thickness direction performance requirements, high strength and toughness requirements, pressure vessel plate and other steel plates,AH36 hull structure steel.The company always adheres to the principle of "quality first, user first", and takes every cooperation seriously. It is our biggest wish that the steel material, specification and quantity can fully meet the requirements of users. With good reputation, high quality products and low price, we are willing to work together with old and new customers to create a great cause. Customers are welcome to visit our company at any time. We are always ready to support you.X-rays or γ-rays are projected on the surface of the steel plate, and rubber can be placed on the other side of the steel plate. Since the radiation propagates through the steel plate and is absorbed, the intensity is different due to the presence or absence of defects, so the film can record the shape and position of the defects. This method is sensitive to the detection of common steel plate defects such as slag inclusions, porosity and pores. The disadvantage is that it is difficult to find the specific depth of the defect and it is not easy to find cracks.AH36 hull structure steelAH36 hull structure steel,"The production method of seamless steel pipe can be roughly divided into cross rolling method (menesmann method) and extrusion method. The cross rolling method (menesmann method) is to pierce the tube blank with the cross roll first, and then extend it with the rolling mill. This method is fast in production, but requires high machinability of tube blank. It is mainly suitable for producing carbon steel and low alloy steel tube.The extrusion method is to pierce the billet or ingot with a piercer, and then extrude it into a steel tube with an extruder. This method is less efficient than the cross rolling method and is suitable for the production of high-strength alloy steel tubes."AH36 hull structure steelWhen providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.
