Carbon steel A387 grade 12 class 1 pressure vessel steel sheet angles

Generally, the production process of A387 grade 12 class 1 pressure vessel steel sheet seamless steel tube can be divided into cold rolling and hot rolling. The production process of cold-rolled seamless steel tube is generally more complicated than that of hot rolling. The tube blank must be first rolled by three rolls, and then be subject to sizing test and cutting after extrusion. Then enter the annealing process. In appearance, the cold-rolled seamless steel tube is shorter than the hot-rolled seamless steel tube, and the wall thickness of the cold-rolled seamless steel tube is generally smaller than that of the hot-rolled seamless steel tube, but the surface looks brighter than the thick wall seamless steel tube, the surface is not too rough, and the diameter is not too much burr.

Main characteristics of 12Cr1MoV Steel: compared with 12CrMoV steel, 12Cr1MoV steel has higher oxidation resistance and thermal strength. The creep limit of 12Cr1MoV steel is very close to the endurance strength value, and it has high plasticity under the condition of endurance tension; the processability and weldability of 12Cr1MoV steel are good, but it needs to be preheated to 300 ℃ before welding, and stress removal treatment after welding. 12Cr1MoV steel is widely used in Superheater, header and main steam pipe of high pressure, ultra-high pressure and subcritical utility boiler.

Cold rolled A387 grade 12 class 1 pressure vessel steel sheet steel sheet can be produced by two high mill, four high reversing mill, multi high reversing mill and tandem cold mill. Although there are still only two work rolls in four high and multi high rolling mills, each work roll is supported by one or more large diameter backup rolls, which can prevent deflection of work roll. As a result, wide and thinner A387 grade 12 class 1 pressure vessel steel sheet steel plates can be produced. For example, 20 high mill can produce as thin as 0. 001 mm sheet, but the two high mill can only produce as thin as 0. 35mm sheet

BBN steel strictly control quality of our carbon steel plate, alloy steel plates and structural steel plates. For A387 grade 12 class 1 pressure vessel steel sheet ASTM A572 Grade 50 structural steel plate, Our Q/C Department will inspect dimension before shipment, making sure structural steel plate thickness tolerance and width, length tolerance are matchable to the A387 grade 12 class 1 pressure vessel steel sheet standard requirements. The company is a good ASTM A572 Grade 50 structural steel plate supplier in the globle market and the head is located in China. Welcome to send us inquiry and questions about structural steel plate.

Our company will accept the product quality objection registration record, pass it to the A387 grade 12 class 1 pressure vessel steel sheet production unit and relevant departments, and timely coordinate the supervision of product A387 grade 12 class 1 pressure vessel steel sheet quality objection. Our company coordinates the relevant department personnel to the customer unit to carry on the investigation, the processing.