BBN STEEL NM600 steel plate 860tons exported to Egypt

Considering the large workload of allocation and transportion for our steel materials, we have built special shipping department, and make it independent form transportation department. The transportation department is in charge of transporting steel materials from our mill and warehouse to the port, and our shipping department is in charge of the shipping matters. So that our whole shipping efficiency is improved, and shorten time for customers to receive goods.

The company will also put Georgetown steelworks on "care and maintenance mode" and temporarily lay off or redeploy about 130 employees working at the steelworks and contractors while some NM600 steel plate maintenance employees will be on staff during the closure. It is stated that unemployment insurance and state-based unemployment support will be available immediately to workers affected by these changes.

Shipbuilding steel plates have always been the key products of our company, and it is sold well in many countries and regions around the world. The thinnest certifiable thickness of our shipbuilding steel plates is up to 3mm. We cooperate with classification societies to certify the shipbuilding steel NM600 steel plate and issue EN10204 3.2 material test certificate. According to the certificate number, the customer can verify the source of the shipbuilding steel plates with the corresponding classification society near them.

As a leading international steel supplier, we have two warehouses, close to Tianjin port and Shanghai port. This superior geographical location effectively saves the domestic transportation cost and greatly improves our service level. At the same time, it also shortens our delivery time and provides more convenience for customers.

No. 45 steel is commonly used medium carbon quenched and tempered structural steel. The cold plasticity of No. 45 steel is generally better than NM600 steel plate. Annealing and normalizing are better than quenching and tempering. No. 45 steel has higher strength and better machinability than Q345 steel. After proper heat treatment, it can obtain certain toughness, plasticity and wear resistance. No. 45 steel NM600 steel plate is suitable for hydrogen welding and argon arc welding, but not suitable for gas welding. Preheating is required before welding, and stress relief annealing shall be conducted after welding.

We guarantee to provide all technical data required by users within one hour to provide reasonable quotation; to provide NM600 steel plate reasonable quotation for products consulted by users within one hour; to provide investigation reception: we guarantee to receive the investigation of users at any time and provide various convenient conditions for users.